MD70MH
11.6mm, Cored, High Voltage, Metal Gear Actuator (7.4V)
The MD70MH is an 11.6mm, metal gear, 13-gram micro servo for higher voltage applications. Featuring a single output ball bearing, cored brush motor, and magnetic rotary encoder, the MD70MH is often used in compact fixed wing UAV and drone applications where space and weight are mission critical concerns. The MD70MH utilizes PWM command protocol at a voltage range from 4.8~7.4 volts.
Part #: 40070S
$55.00
Maximum of 20 units per part # are available for purchase on our website.
Contact Sales directly to discuss purchases over 20 units:
Actuator Sales
sales@hiteccs.com
| Performance Specifications | |
|---|---|
| Command Protocol |
PWM PWM / TTL |
| Operating Voltage (V) |
Min: 6.00
Max: 7.40 |
| Weight (g) | Min: 13.30 |
| Stall Torque (kgf•cm / oz•in) |
Min: 3.1 / 43.05
Max: 3.8 / 52.77 |
| No Load Speed (sec/60°) |
Min: 0.15
Max: 0.12 |
| Running Current (mA) |
Min: 200
Max: 240 |
| Stall Current (mA) |
Min: 1000
Max: 1300 |
| Circuit |
Digital |
| Rotation |
Standard |
| Operating Voltage (V) |
Min: 6.00
Max: 7.40 |
| Torque Range |
Min (KG/CM): 3.80
Max (N/CM): 37.25 |
| Max Speed (SEC/60) | 0.12 |
| Physical Specifications | |
|---|---|
| Case Size (mm) | 11.60 |
| Dimensions (mm) | 23.6 x 11.6 x 29.0 |
| Weight (g) | 13.30 |
| Motor Type | Cored Metal Brush |
| Potentiometer |
Magnetic Encoder |
| Gear Material | 1 Heavy Duty Resin & 4 Metal |
| Horn Gear Spline | M25T (Ø5) |
| Case Material | Engineering Plastic |
| IP Rating |
N / A |
Contact Sales directly for accessories and/or replacement parts:
• Case Set
• Gear Set
• Horn Set
Actuator Sales
sales@hiteccs.com
Standard Programming Functions
- End Point Adjustments
- Direction
- Fail Safe
- Dead Band
- Speed (Slower)
- Soft Start Rate
- Overload Protection
- Data Save / Load
- Program Reset
IMPORTANT INFORMATION > DPC-20 PROGRAMMER
- Hardware Type: PC USB-C to 3-pin (PWM/TTL) and 4-pin (RS485/CAN) interface.
- Capable of configuring and testing HITEC digital servo actuators.
- Compatible with various control methods (PWM, RS485, CAN), offering a seamless transition from legacy DPC-11, DPC-485, and DPC-CAN units.
- Different servo actuator series require dedicated UI programs due to variations in communication protocols.
- Ensure you connect the appropriate power supply to the DPC-20 for the connected servo actuator.
- For servo actuators (5/7 Series, 9 Series, D/MD Series), connect to the 3-pin port on the DPC-20, and connect the power supply to the BAT- and BAT+ pins on the 4-pin port, paying careful attention to polarity.
- DPC-20 Wiring Diagrams are located on the DPC-20 UI HUB DOCUMENTATION.
Additional downloads can be found on our ACTUATOR RESOURCES page under our Support tab.
Contact Sales directly if you are unable to locate a specific resource download:
Actuator Sales
sales@hiteccs.com
