D485HW
19.8mm, Cored, Wide Voltage, Karbonite Gear Actuator (7.4V)
Part #: 36485S
$44.99
Maximum of 20 units per part # are available for purchase on our website.
Contact Sales directly to discuss purchases over 20 units:
Actuator Sales
sales@hiteccs.com
| Performance Specifications | |
|---|---|
| Command Protocol |
PWM PWM / TTL |
| Operating Voltage (V) |
Min: 4.80
Max: 7.40 |
| Weight (g) | Min: 45.00 |
| Stall Torque (kgf•cm / oz•in) |
Min: 5.2 / 72.21
Max: 7.5 / 104.16 |
| No Load Speed (sec/60°) |
Min: 0.2
Max: 0.15 |
| Running Current (mA) |
Min: 250
Max: 320 |
| Stall Current (mA) |
Min: 1000
Max: 1500 |
| Circuit |
Digital |
| Rotation |
Standard |
| Operating Voltage (V) |
Min: 4.80
Max: 7.40 |
| Torque Range |
Min (KG/CM): 7.50
Max (N/CM): 0.00 |
| Max Speed (SEC/60) | 0.15 |
| Physical Specifications | |
|---|---|
| Case Size (mm) | 19.80 |
| Dimensions (mm) | 39.8 x 19.8 x 38.0 |
| Weight (g) | 45.00 |
| Motor Type | Cored Metal Brush |
| Potentiometer |
Conventional |
| Gear Material | 1 Metal-Karbonite & 3 Karbonite Resin |
| Horn Gear Spline | 25 Segment / Ø6.0 |
| Case Material | Engineering Plastic |
| IP Rating |
N / A |
Contact Sales directly for accessories and/or replacement parts:
• Case Set
• Gear Set
• Horn Set
Actuator Sales
sales@hiteccs.com
Standard Programming Functions
- End Point Adjustments
- Direction
- Fail Safe
- Dead Band
- Speed (Slower)
- Soft Start Rate
- Overload Protection
- Data Save / Load
- Program Reset
IMPORTANT INFORMATION > DPC-20 PROGRAMMER
- Hardware Type: PC USB-C to 3-pin (PWM/TTL) and 4-pin (RS485/CAN) interface.
- Capable of configuring and testing HITEC digital servo actuators.
- Compatible with various control methods (PWM, RS485, CAN), offering a seamless transition from legacy DPC-11, DPC-485, and DPC-CAN units.
- Different servo actuator series require dedicated UI programs due to variations in communication protocols.
- Ensure you connect the appropriate power supply to the DPC-20 for the connected servo actuator.
- For servo actuators (5/7 Series, 9 Series, D/MD Series), connect to the 3-pin port on the DPC-20, and connect the power supply to the BAT- and BAT+ pins on the 4-pin port, paying careful attention to polarity.
- DPC-20 Wiring Diagrams are located on the DPC-20 UI HUB DOCUMENTATION.
Additional downloads can be found on our ACTUATOR RESOURCES page under our Support tab.
Contact Sales directly if you are unable to locate a specific resource download:
Actuator Sales
sales@hiteccs.com
